MFx Explosionproof Melt Pressure Transmitter - 2-wire 4-20 mA
Features
- The entire amplifier/sensor assembly of an MF Series Melt Pressure Transmitter is packaged in a stainless steel welded enclosure with a conduit cable fitting.
- This metal enclosure is completely sealed from the atmosphere, and is approved to meet hazardous area requirements.
- The MF converts applied pressure at the point of measurement to a proportional voltage output signal.
- An amplifier converts the strain gage signal to a 4-20mA output.
- The small capillary tube filled with a special medium isolates the amplifier from potential thermal damage.
- Factory Mutual approved Explosion proof for Class I,
- Division 1, Groups A, B, C, D, and Dust-Ignition proof for
- Class II, Division 1, Groups E, F, G
- Other approvals: CE, NEMA 4/IP65
- High-level output 2-wire, 4-20 mA
- Accuracy: <±0.25% FSO (H); <±0.5% FSO (M)
- Internally generated 80% calibration signal (R-Cal)
- 1/2-20 UNF thread standard, M18x1.5 also available
- Fluid-filled system for temperature stability
- 15-5 PH stainless steel diaphragm with Armoloy coating
- standard (others available on request)
- 17-7 PH corrugated diaphragm with TiN (Titanium Nitride) coating for ranges below 100 bar (1500 psi)
related products
